Day 6 - Section 1 - Sensing the light

Before explaining how the Serial monitor works, let's have a look on the code that we have to upload to the NodeMCU, in order to measure the light. Study, copy and then paste it into the Arduino IDE:

void setup()
{
    Serial.begin(9600);  //Begin serial communcation
}

void loop()
{
   Serial.println(analogRead(A0)); //Write the value of the photoresistor to the serial monitor.

   delay(10); //short delay for faster response to light.
}

A few words about the program:
First, in the setup() section, we initialize the communication speed between the computer and the NodeMCU (Serial.begin(9600);).

In the loop() section, we read the analogue value of pin A0 (analogRead(A0);) and then we display it into the Serial Monitor in a new line (Serial.println();). Notice here that there is another command (Serial.print();) which prints the output without opening a new line. But, here we use Serial.println(); command.
The last command delay(10); is telling the NodeMCU to wait for a little time (10ms) before continuing.

In order to open the serial monitor in Arduino IDE and watch the values we need to press the icon with the magnifying glass:


Then you will see a picture like this, that will be refreshing fast:


Try now to throw some light on the photoresistor (maybe with a flashlight or using your mobile phone) and watch the values changing. The limits are 0-1023 so any value between these limits represents an amount of light at any given moment.

Play, experiment and learn by making! After this we can proceed to the next section which is about handling a laser pointer by NodeMCU.